![]() “Dynamic microphone element with cardioid polar pattern” That would give a consistent, even sound. ![]() The best thing about the mesh pop filter is that you can position the mic about 3 inches behind it and then get as close as possible to the pop filter when you’re talking, ideally with your nose almost touching the mesh. If you want to hit the “sweet spot” of this mic for the best sound, you want to be about 3 inches away with the gain settings on your sound card turned up to around 90%.Ĭonsider investing in either a foam ball or a mesh pop filter if you want to produce the best quality sound.Ī foam ball is ideal if you’re outside of a studio environment, interviewing people, or possibly in windy conditions.Ī mesh pop filter can be had for under £10 and is best attached to a sprung scissor arm boom stand. ![]() You can always try a “side-address” positioning slightly off-axis, but keep in mind the further away you are from the mic, the quieter the recording. My comment: This microphone is designed to be spoken into directly on the top, and I’m afraid to say that plosives can be a problem. “Multi-stage grille design offers excellent protection against plosives and sibilance without compromising high-end clarity.” I’m copying the exact words from the booklet with my commentary appended: 1. Let’s run through each of the following 11 items from the diagram. The plastic stand and two leads are included. The diagram below has been scanned directly from the paper instruction booklet. If you’re like me, you want something relatively inexpensive yet formidable.Īfter watching, reading and of course listening to microphone reviews, I made the purchase decision. The general consensus seems to be that the Heil PR40 is considered a top-end podcasting mic… if you can afford it. Listen on Soundcloud Why I Purchased the ATR2100 Recorded by Small Biz Geek on August 27, 2015
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |